While some pictures show it installed with no rear seats, we assure you it fits with all seats installed. You are able to remove the bar with 6 bolts, to give complete unobstructed access to your back seat.

High-quality Energy Suspension polyurethane bushings at both ends help remove some of the slop that the OEM rubber bushings allow, and the fact that we pre-lube them during assembly AND send more lube with the kits means you can expect many years of reliable performance from them.

Our parts are all precision machined from 6061-T6511 billet aluminum and 17-4 Stainless steel.  Tabs are laser-cut for exact fit and all hardware is high-strength with OEM-quality plating to resist corrosion.  Our arms weigh approximately 1 pound less than the OEM parts (each) but are significantly stronger in all directions.

We use a high-end, FK stainless-steel, Teflon-lined spherical bearing for the joint that is angled 5-degrees to prevent joint bind at full droop.  This bearing is replaceable and will last for years without issue.

In short, we have done everything we can to make sure these parts fit exactly right, provide all the adjustment you could need (up to +/- 8mm as compared to stock) and give nothing but trouble-free years of service even under harsh conditions.